4" square mesh knotless netting constructed of rugged high-strength fiber. Attaches to structure using integrated rope cording and adjustable cinch straps. The net structure is supported with 3 sets of reinforcement ropes affording up to 25 dimensional adjustments in width and length. Available in 11 sizes from 7'-27' square and 12'x17' to 22'x27' rectangle. Custom sizes are also available. Measure width and length of work area to be protected to order correct size.
| Phase of Construction |
| Roof sheathing, floor sheathing, floor joist installation, roof truss installation |
| Manufacturer’s Device Page |
| Guardian Fall Protection |
| Installation |
| If plumb and line braces removed to install netting, these must be reinstalled properly. Lay net on floor to choose appropriate perimeter rope. Attach 1 corner of net to top plate using cinch strap and fasten tighten. Repeat for all 4 corners. Add cinch straps every 4' around perimeter of net until all 4 sides are secured. Position strap buckles under top plate to avoid trip hazard. Tighten netting with 2 cross ropes and tie off at each corner. Net should be flat with 6" maximum dip in center. Do not draw the walls in toward net when tightening straps, temporary reinforcement of framework may be necessary. Warning: Users must strictly adhere to the manufacturer’s inspection, installation, maintenance and use directions; and must follow local, state and federal safety regulations. Failure to do so could result in serious injury or death. |
| Manual |
| Instruction Manual |
| Vendor |
| guardianfall.com, incord.com, associated-scaffolding.com, toolup.com, ezsafetysupply.com, ordexsupply.com |
| Cost |
| $182-1,100 depending on size |
